Works fine CPU Intel Core2 Dual 2.7GHz 2XRB44GV Very stable even with dual-cores enabled. Locks up under heavy load across wireless No Apparent Problems, Disabled any unneeded devices in the BIOS Up to 1300 users with summary 200Mbit traffic. Works fine on 3.7/3.4 if multi-cpu=no, BUT 3.5-3.7 fail to boot with E4600 processor and multi-cpu=yesīoot from USB stick. Multi-cpu smp works great, onboard NIC not supported by RouterOS 4.6 yet though, must use pci/pci express nics Works fine, Ethernet but not working (IRQ 9), set in BIOS Security/XD Tegnology to disable shared IRQ for PCI devices, decrease nic performace. Works fine but integrated ethernet (just disable) goes up and down on reboots multi-cpu= yes. Onboard Ethernet Works perfectly.Ĥ core's, 2gb ram, 32gb ssd, no problems.
RouterOS boots and works with SATA disk set to 'IDE compatibility mode'.Įxcellent performance under 2.9. Works ok, PATA controller (JMicron JM363) and internal Ethernet successfully recognized. Works great for pentium dual-core e2160, hdd pata and sata, 1,5gb ram dual channel mode, except the attansic l2 ethernet onboard card is not recognized. Not supported PATA controller (JMicron JMB363), ROS can boot from USB flash drive internal ethernet not recognized. Winbox via MAC = problem, disconnects after 3 seconds. Integrated Gigabit NIC Marvell Yukon 88E8001 works fine but only at 100Mbps. Both integrated Gigabit NIC (Marvell Yukon 88E8056 & 88E8001) works fine but only at 100Mbps. Mikrotik has not driver compatibility with this motherboard. Maybe it's just Asrock bad motherboard don't know if the problem is in intel 82801G chipset tested on 2 motherboards, never tested on 2.9.x PCI not tested, but should works.īad performance, locks up under heavy load, supports multi cpu, PATA not supported, integrated ethernet not recognized. Boot from CF card connected to PATA (small, notebook).
0 kommentar(er)
